42
POWER FOR OPERATION
All power slide systems operate on 12 volt DC power provided by a
convertor, being the main source, requiring 120 volt power and/or a
12 volt battery, fully charged. A 12 volt distribution load center,
breakers and fuses are provided for each slide. Tow vehicle 12V
power may also be used as required. Breakers, 12 volt, are
automatic resettable.
Supplement your battery by either one of two choices:
1. Hook up a 120-volt AC power cord to recreational vehicle for
converter operation.
2. Use 12 - volt power through the tow vehicle to the recreational
vehicle battery or batteries.
Either of these methods will help ensure maximum electrical power
for the slide-out motor, as well as maintain your battery.
Battery is an after market item, not supplied by manufacturer.
TRAILER SET-UP REQUIREMENTS - GENERAL
Note:
1. Before operating the slide-out room, level the trailer front-to-rear
and side to side.
2. Extend all stabilizer jacks to make solid contact with the ground
and/or on solid blocks. Placing stabilizer jacks onto a hard
surface allows the coach to remain square and assure a good
weather tight seal between the room and trailer sidewall.
BELOW FLOOR SLIDE SYSTEM
Under floor slide-out mechanism steel bars are welded to the frame
members. A “cog” track is welded to bottom side of cross member,
matching with a gear attached to drive shaft, “LCS (Lippert
Component System.) As motor turns, a actuator moves the gear on
the track ( ram ). A cross shaft, front to rear ram connects the
second ram, moving the opposite end of slide. Mechanism operates
the same, flush or standard floor.
PDF created with pdfFactory trial version
www.pdffactory.com
