44
move the room. Press on desired position and hold until room is
seated, and gasket is slightly compressed. Do not force the room to
move beyond sealing as damage could occur.
MANUAL OVERRIDE:
BELOW FLOOR SLIDE OUT
Should a power failure occur (no 120 volt AC power or the battery
looses its charge), follow the directions listed:
There is a 1/2” shaft coming through the main rail of frame. On the
end of the shaft is a 3/4” nut attached. Use a 3/4” socket with
extension and ratchet to move the slide. On some units the stabilizer
jack crank handle will also work on this shaft with the attached 3/4”
nut.
ABOVE FLOOR SLIDE-OUT
Manual Override (Single or Double Rams)
Should 12 volt power fail and there is no 120 volt AC power
available, follow the directions listed.
Access to the ram under the floor of slide, sofa or dinette, is from the
front. Lippert Component System has a smaller motor, less draw
and requires a 5/8” socket, ratchet and probably an extension shaft.
BLINDS
Any blinds or night shades with loose cords, such as mini-blinds
CANNOT
be installed in bunks designed and built for young
children. Cords could become wrapped around their neck.
VENTURE RV recommends these shades be in the UP position for
travel to avoid lower metal holder being in contact with garnish on
window, wall panels, etc.
PDF created with pdfFactory trial version
www.pdffactory.com
