62
Installing Propane Containers
Venture recreational vehicles are equipped with 20 or 30 pound
propane containers, depending on floor plan models.
Mounting and attaching instructions are listed below:
1. Thread the long rod into the base plate.
2. Set both bottles into place as shown.
3. Drop the double hook bracket over the rod and hook onto the
bottle.
4. Attach the wing-nut to hold the bracket and tighten to hold the
bottle to the plate.
5. Attach the regulator with the vent down to the bracket.
6. Attach the main hose from the regulator to the manifold fitting in
the frame.
7. Attach two short pigtail hoses to the regulator and bottles at the
ACME fitting.
8. Test all propane connections for leakage.
A warning label has been located near the propane container. This
label read as follows:
THIS GAS PIPING SYSTEM IS DESIGNED FOR USE WITH PROPANE ONLY.
DO NOT CONNECT NATURAL GAS TO THIS SYSTEM.
Securely cap inlet when not connected for use. After turning on gas, except
after normal cylinder replacement, test gas piping and connections to appli-
ances for leakage with soapy water or bubble solution. Do not use products
that contain ammonia or chlorine.
CAUTION
!
1.
Knob to open and close main valve.
2.
Complete valve assembly.
3.
“10% valve“, (small brass knob or
slot screw).
4.
Container mounting stand.
PDF created with pdfFactory trial version
www.pdffactory.com
