VeEX VePAL MX100e+, Руководство пользователя

Страница: 57 / 115

Go back to top Go back to ToC
9.1.2 Control Settings
MX Discover:
Configures the loop up and loop down commands necessary to control the far-end unit. The user is allowed to configure the
commands manually or automatically.
Manual selection:
User must input the destination MAC/IP address of the far-end device including the command
type
Peer-to-Peer:
When the local unit connects to the remote (peer) partner, it loads the same configuration profile
(header, traffic, and frame size) to the remote partner, with the MAC and IP addresses inverted
Throughput - Control Setup (Peer-to-Peer) Throughput - Control Setup - OAM Discover
OAM Discover:
OAM discovered devices will be listed. Select an OAM link partner and press the Loop Up button to set the far-
end device into loopback mode. This will send a loop down command at the end of the test.
For further instructions on connecting to an OAM device, please refer to OAM Discover under 7.1.4 Control Settings in the BERT
section.
/ e_Manual D07-00-050P RevD00 Page 57 of 115