VeEX VePAL MX100e+, Руководство пользователя

Страница: 59 / 115

Note:
Please see 7.1.1 Header Settings in the BERT section for further details on MAC and VLAN configuration options.
Note*:
VLAN and MAC Flooding are only available for single stream testing.
Throughput - VLAN Setup Throughput - MAC Setup
Multiple Streams - MAC/IP address setups
If all streams are going to the same far-end unit, the MAC/IP destination addresses must be the
same on all of the streams.
If any of the traffic streams are going to more than one far-end unit, please ensure that the correct
MAC/IP destination addresses are configured for the respective streams.
Go back to top Go back to ToC
9.1.4 Traffic Settings (Individual Streams)
In the Traffic tab the user is able to configure the traffic profile per stream, including frame size selection, traffic type, and transmit
rate. If the same traffic type applies to all streams, apply this profile to all streams using the Apply to All button.
Frame Size:
Enter the frame size when a Layer 2 or Layer 3 is selected. Frame size configuration is not available for Layer
1. Frame sizes can be from 64 bytes to 1518 bytes, in addition to jumbo frames up to 9k bytes.
Traffic Flow:
Select from Constant, Ramp, Burst, or Single Burst traffic flow.
BW (Transmit Bandwidth):
Configure the transmit rate for the stream.
Note:
The bandwidth allocation per stream is already configured in the General Settings tab, but can be modified in this
screen as well.
For more information on Traffic Settings, please see 7.1.2 BERT Traffic Settings .
Throughput - Traffic Setup - Constant Throughput - Traffic Setup - Ramp
/ e_Manual D07-00-050P RevD00 Page 59 of 115