Page 38
DIAGNOSTIC SCREEN STATUS
Allow a diagnostic screen to be displayed. Can be useful when troubleshooting, but
requires some technical knowledge.
TEST BUTTON DISABLED
Allows the round test button on the controller to be disabled, in cases where higher
security is required.
REMOTE CONTROLS – MENU 11
The controller is capable of learning up to 64 Centurion Nova remote controls / transmitters. Each
transmitter can have up to 4 buttons. Each transmitter learned into the system is assigned a unique
transmitter ID.
PRESS VALID BUTTON
If the remotes MENU has been locked as discussed later, only by pressing a button of a
transmitter learned into the system, can this MENU be accessed.
ADD REMOTES
Any button can be set to control the trigger, pedestrian, free exit, holiday lockout or
courtesy light inputs. When adding transmitters it is recommended that a record be kept
of the ID number allocated by the system to each respective transmitter and the person
to whom the transmitter is given. This is necessary should selective deletion be required
at a later stage.
DELETE REMOTES
Transmitters can be edited at any stage according to one of the following:
?
DELETE REMOTE BY ID -
Each transmitter can be deleted individually
according to its unique ID. To facilitate this, a record of the ID and the
person to whom the ID has been assigned must have been made at the time
of learning the transmitter into the system.
?
DELETE REMOTE BUTTON -
The operation of a button on a particular
transmitter can be cleared. Ie It allows for instance Holiday Lockout set on one
remote to be cleared without affecting the other operations that the transmitter
performs.
?
DELETE REMOTE BY BUTTON –
use this procedure to delete the transmitter
if is present.
?
DELETE ALL REMOTES –
clear the entire remote memory.
EDIT REMOTES
Change the function of one button to another.
REMOTE MENU LOCK STATUS
The remote control menu can be locked, requiring the use of a valid transmitter in the
system to add new transmitters.
Page 39
Table 1 Factory Defaults Schedule
PARAMETER DESCRIPTION
UNIT
MIN
DEFAULT
MAX
South African Standard Profile
Auto-Close Enabled
Auto-Close Time
Mode of Operation
Motor M Opening Force
PCM Enabled
Leaf Delay Enabled
Motor M Closing Force
PCM Type
Leaf Delay
Motor S Opening Force
PCM Stop Short Distance
Motor S Closing Force
PCM Force
Max. No. Collisions
Collision Alarm Output
Auto-Close Override Time
Auto-Close from Fully Open
Auto-Close from Partly Open
Auto-Close from Partly Closed
YES/NO
mm:ss
S,R,C
Level
YES/NO
YES/NO
Level
M,S,M & S,SS
mm
Level
mm
Level
% (A)
Collisions
B,C,P,S,L
s
00:00*
1
NO
NO
1
1
1
1
1
3*
0
1
Max (6)
YES
YES
Max (6)
Max (6)
40
Max (6)
15
255
2*
0:15
Standard
3
NO
NO
3
Master Only
10*
250*
3
5
3
3
4
Buzzer
3
04:00*
15*
NO
NO
YES
YES
YES/NO
YES/NO
YES/NO
* -Settings are fixed across standards
** -Settings are not configurable via the GUI
Table continue on next page.
Opening Speed
Closing Speed
Ramp Up Distance
Ramp Down Distance
Crawl Distance
Torque Limit
mm/s
mm
(A)
10
10
20
20
5
4
Max
Max
400
400
400
15
30
30
30
30
10
11
mm/s
mm
mm
Pre-Close Delay Time
Pre-Open Delay Time
s
s
0
0
0
196
196
Factory Defaults Schedule
Factory Defaults Schedule
