![background image](http://html1.mh-extra.com/html/vdo/contisys-obd-v3-0/contisys-obd-v3-0_instruction-manual_3754408042.webp)
FastCheck
40
Clutch Replacement (manual transmission):
1. After a new clutch has been installed perform the ‘Clear Clutch Engagement
Point’ function.
2. The vehicle will then learn the new clutch engagement point as the vehicle is
driven.
Parking Brake Module Replacement:
1. After the Parking Brake Module has been replaced perform the ‘Inclination
Sensor Calibration’ function.
2. If the vehicle has manual transmission perform the ‘Clear Clutch Engagement
Point’ function.
3. The vehicle will then learn the new clutch engagement point as the vehicle is
driven.
Any other EPB system component has been replaced:
1. DTCs should be read and cleared.
2. The 'Assembly Check' function should be performed to check the operation of
the parking brake system.
3. If the 'Assembly Check' function fails, DTCs should be read again and the
problem investigated.
The Parking Brake will not engage when manually operated via the button:
1. Ensure that the system is NOT in 'Maintenance Mode'. If it is, then perform the
'Exit Maintenance Mode' function.
2. Read DTCs, there may be a DTC stored which will indicate the area of the fault.
3. Clear DTCs, there may be an intermittent fault on the system which needs to be
cleared.
4. Perform the 'Static Apply' function. This will send a command directly to the
Control Module which will then close the actuators to the nominal 'engaged'
position.
5. Check the switch/button.
6. Check the actuators themselves or the wiring from the ‘Control Module’ to the
actuators.
Содержание CONTISYS OBD - V3.0
Страница 1: ...Instruction Manual ContiSys OBD 02 2010 3 0 EN...
Страница 2: ......
Страница 143: ......
Страница 144: ......