![background image](http://html1.mh-extra.com/html/vdo/contisys-obd-v3-0/contisys-obd-v3-0_instruction-manual_3754408075.webp)
FastCheck
73
Follow the on screen instructions which indicate the order the wheels are to be
programmed in. The spare wheel is included along with the other wheels, but if this
option is not supported by the vehicle, a message will appear after a few seconds to
indicate this.
Note
: Remember to reset the correct tyre pressures when finished.
Renault
General
Note
: For Renault vehicles which use the ‘Renault Card Keyless Ignition System’ and
the ‘START’ button (Megane II, Scenic II etc.):
To switch the ignition on WITHOUT starting the engine:
1. Unlock the car with the remote (card).
2. Insert the card into the card reader.
3. Without pressing the brake or clutch pedal push and hold the ‘START’ button for
at least 5 seconds. The dash should illuminate and the button should be released.
All diagnostics can now be carried out.
TPMS is the Tyre Pressure Monitoring System.
Each valve sensor has a unique code and is matched to a particular wheel. This is
programmed into the UCH control module. This enables a faulty wheel to be identified
(given that the receiver can identify which wheel is transmitting). The sensor emits an
RF (Radio Frequency) signal containing the valve code, status and tyre pressure. If
wheels are to be swapped around then reprogramming will need to be carried out to
identify the new position of the wheel.
Each valve sensor has a coloured ring attached to the valve nut, each colour
corresponds to a particular wheel position:
Front Left: Green
Front Right: Yellow
Rear Left: Red
Rear Right: Black
It is recommended that if tyres are moved around that the coloured rings are replaced
in the correct wheel position.
Each valve sensor will emit a signal every hour if stationary, and every 15 minutes if a
leak is present. If moving it will emit a signal every minute if no leak is present, and
every 10 seconds if a leak is present.
Note
: In the live data the tyre pressures will display a default value of 3.5 bar until the
valves have been forced to transmit.
Содержание CONTISYS OBD - V3.0
Страница 1: ...Instruction Manual ContiSys OBD 02 2010 3 0 EN...
Страница 2: ......
Страница 143: ......
Страница 144: ......