VDO CONTISYS OBD - V3.0, Инструкция по эксплуатации

Страница: 27 / 144

FastCheck
25
Select the required menu option using the and keys and press to confirm.
The service tool will attempt to establish communication with the vehicle system. If
communication is unsuccessful, refer to
‘Communication problems’, page 10 .
Read DTCs
If any DTC codes are present in the system, a screen will be displayed informing you
how many codes were found. This will then be replaced by the first DTC code. DTC
codes are generated according to the vehicle and system manufacturer.
A typical DTC code
The fault number is displayed first, followed by the DTC code. In this example the fault
displayed is DTC number 38 - Right Low Pressure Sensor Circuit Signal High or Open
Circuit. If the description text is too long to fit on the display, '[...]' appears in the
bottom right corner of the screen. This indicates that the text can be scrolled using the
and keys to view the rest of the description.
To view the next DTC (if more than 1 was found), scroll to the end of the text and press
the
key.
To return to the menu, scroll to the end of the text and press the key.
Clear DTCs
Diagnostic trouble codes can be cleared using the 'Clear DTCs' option. When using
the option you will be prompted to turn the ignition off. Wait until prompted before
switching the ignition back on.
Start the engine to force the control module to run a system check. Verify that the
code(s) have been cleared by selecting 'Read DTCs'.
Note: Reading DTC(s) without first starting the engine will only confirm that the stored
DTC(s) have been cleared. Faults may still be present in the system causing a DTC to
be stored next time the engine is started.
BMW/MINI vehicles
Note: To switch the ignition ON for vehicles fitted with a start/stop button, insert the
remote key-fob fully into the ignition slot then press the start/stop button once (without
any foot pedals depressed).
1. Read DTCs
2. Clear DTCs
DTC 1 - 38 Right Low
Pressure Sensor
Circuit Signal High{ }