VDH Products PROBA, Инструкция по установке и эксплуатации

Страница: 28 / 78

VDH Products BV Document 063319 - version 3.12 Page: 28 of 78
3 The Personal Computer
The PROBA110 can be connected to the computer.
There are two versions from the PC software. There is a DOS version and a Windows version.
For the DOS version there is a special manual with document number xxxxxx
For the Windows version there is a special manual with document number xxxxxx
4 Installation
Warning:
While making connections and adjustments all equipment should be switched off !
This warning applies to both the connection of the PROBA110 ripening room control computer and the connection of the Personal
Computer and the network interface PROBA120 .
A number of adjustments depend on the wishes of the future user and the local situation. Therefore it is not possible to preform all
settings at the factory.
It is expected that the installer performs a number of adjustments before the installation is put into service:
* setting of selection parameter for the applicable I/O board model (parameter 6200).
* method of temperature control.
* setting of the sensors.
* setting of the alarms.
* setting of zones, fans, cooling, heating, etc.
* temperature read-out in

C or

F ?
* Stand-Alone or Network operation ?
* Standard ripening programs ?
4.1 PROBA110 installation
During the installation of the PROBA110 some information must be recorded for later use. Appendix D (Fill up list
Installation, page 46) contains a table which can be filled up.
Fill also the serial number of the control computer and the relay board up in the table. Make sure that the control computer is
connected to the relay board with the same serial number. The control computer and the relay board are adjusted to each
other. Changing can cause false indications.
If the PROBA110 is connected to a network, make sure that the network address of each control computer is unique. This
address is programmed in the Internal Parameters.
Only use each address once on a network !
Over the front of the PROBA110 control computer the Interne Parameters can be programmed. These parameters
determine the operation of the PROBA110 . With these parameters it is possible to adjust the PROBA110 to the local
situation.
4.1.1 Mounting of the PROBA110
The two main components of the PROBA110 , the so-called relay board and the processor (the black box) can be
mounted in two different ways:
*
On the wall; relay board and processor together in a plastic housing.
* In a switch cupboard; processor in the door and the relay board on the back.
Consult the chapters on connecting the relay board and the connection diagram in Appendix M (page 74).
4.1.1.1 Wall mounting
The PROBA110 in self-contained housing can be mounted between the doors of the ripening rooms. This
allows the control of the processor and the read-out of the temperatures to take place near the product.
The switch-cupboard for the room(s) is controlled by the
PROBA110 . The wall-mount PROBA110 is
delivered ready for use.
4.1.1.2 Switch cupboard mounting
In case the PROBA110 is mounted in a switch-cupboard (eventually more than one per cupboard), the
connections can be made directly to the relay board inside the switch-cupboard. The control and read-out
can be performed on the front of the switch-cupboard. Since the distance between the processor and the
relay board is unknown to us, please specify the length of the connecting cable with your order. By the
way the maximum length is 1 meter.
For each
PROBA110 a square hole of 138x138mm should be made in the door of the switch-cupboard. A
mounting bracket is shipped with each PROBA110 .