VDH Products BV
Document 063319 - version 3.12
Page:
22 of 78
Rotate the key switch to
ON
and remove the key.
Please note:
If the ventilation is stopped, all programmed ventilations of the ripening room
are stopped. No more ventilation takes place, because the first as well as
the second cycle is switched off.
During a ripening program it is possible to start the ventilation (once more), if
no ventilation is active. This should be stopped first.
Make sure the key switch is in the
PE
position.
Press the
SET
key and next the
TEMP/VENT
key.
The length of the ventilation cycle can be set.
This time is shown in hours and minutes.
Using the
UP
and
DOWN
keys the length of the ventilation cycle can be
adjusted. Press the
SET
key to acknowledge the correct setting.
If continuous ventilation is required, the ventilation time should be increased
as much as possible. The upper display shows the text 'CONT'.
If no ventilation is required, the ventilation time should be decreased as
much as possible. The upper display shows 'OFF'.
Next set the ventilation interval. This interval determines how often a
ventilation should take place.
The interval time is indicated in hours.
After the
SET
key is pressed, the new programmed ventilation cycle will
become active. The
VENT
LED will light to indicate that the room is being
ventilated.
Rotate the key switch to the
ON
position and remove the key.
Содержание PROBA
