VALTIR QuadGuard M10, Руководство по эксплуатации продукта

Страница: 35 / 60

Valtir.com 34 Revision F August 2022
QuadGuard ® M10 24” Final Inspection Checklist
Site Location: _____________________
Date: ________________________
Inspector:
_________________________________
Refer to the QuadGuard
®
M10 24” manual and / or drawing package.
Transition Panel fits for the offset (p. 11)
Clearance of 30” behind rear Fender Panels for slide back (p. 14)
Anchor nuts are torqued to manufacturer specification (p. 16)
Top of Nose panels are 32 1/8” above concrete pad (p. 19)
Cartridges are level and the same height in each Bay (p. 19)
Correct Cartridge is placed in each Bay and pointing to front of system
(p. 19)
Cartridge Hold Down Bracket is secure and engaged with Nose Cartridge
(p. 19)
Every hole and slot in Backup and Monorail is anchored (pp. 22, 24)
If no transition, check for narrow side panels at backup (p. 23)
Anchor stud(s) are 1.5” maximum above the pad) (p. 24)
Diaphragms attached to the Monorail guides (p. 25)
Diaphragm Shims installed between Diaphragm & Monorail guides (p. 25)
Each Fender Panel has a tension Die Spring (p. 27)
Mushroom Washers lay flat in slots (p. 27)
Monorail has End Cap attached (p. 28)
Nose Cartridge is at the same height as Bay Cartridges (p. 30)
Fender Panel gap is .78” [20 mm] for Narrow systems (p. 33)
Bolts and nuts are properly tightened (p. 33)
System is clear of debris