VALTIR QuadGuard M10, Руководство по эксплуатации продукта, Страница: 38 / 60

Valtir.com 37 Revision F August 2022
7) Remove all crushed Cartridges.
8) All Diaphragms are in usable condition. Diaphragms which are bowed or have bent legs
must be replaced.
9) Each Fender Panel is properly attached with Mushroom Washer Assemblies. Damaged
Fender and Transition Panels must be replaced.
Warning
Anchor Torque and Clearance Requirements
Torque Requirements – Adhesive Manufacturer Spec
Anchor clearance above nuts – Figure 20, p. 24
Fender Panel Critical Clearances
Fender Panel Gap– .78” [20 mm]
10) Check the gaps between Fender Panels . The maximum gap allowed for these
overlapping parts (including Fender Panels overlapping Panels behind the system) is
.78” [20 mm] .
Important:
Ensure the Mushroom Washer Assemblies are torqued to the end of
the threads. If the gaps between the Fender Panels are still too large, it may be
necessary to replace bent parts.
11) Replace all crushed Cartridges and damaged Cartridge Support Brackets. See Cartridge
Placement on page 19.
12) Remove damaged Nose Assembly. Attach the new Nose to the first Diaphragm. See
pages 30 - 32 and 47 for Nose attachment instructions.
13) All bolts on the system are adequately tight.
14) Site is free from debris.
15) The QuadGuard ® M10 is now ready for use.
Figure 36
Fender Panel Gap
MAXIMUM GAP = .78” [20 mm]
FENDER PANEL
UNDERLYING FENDER,
TRANSITION, EXTENSION
OR SIDE PANEL