VALTIR QuadGuard M10, Руководство по эксплуатации продукта

Страница: 29 / 60

Valtir.com 28 Revision F August 2022
Important:
Starting from the Backup, attach and tighten each Bay section one
at a time.
Step 6
Check Diaphragm spacing to ensure 36” [914 mm] between rear faces of consecutive
Diaphragms as shown in Fender Panel assembly drawing (Figure 27).
Step 7
Once proper spacing has been achieved, tighten the Mushroom Washer Assembly (small
hex) nut until it reaches the end of the threads.
Assemble the remaining Diaphragms and Fender Panels following the same procedures.
8)
Attach End Cap
Attach the End Cap to the front of the first Monorail segment, as shown below and the
Monorail Assembly drawing.
Figure 27
Proper Diaphragm Spacing
Figure 28
Monorail End Cap Attachment
FENDER PANEL
DIAPHRAGM
OR BACKUP
BAY SPACING
36” [914 mm]
DIAPHRAGM
MONORAIL
5/8 LOCK WASHER
5/8 HEX NUT
5/8 X 3 1/2 G5 HEX BOLT
END CAP