VALTIR QuadGuard M10, Руководство по эксплуатации продукта

Страница: 27 / 60

Valtir.com 26 Revision F August 2022
7) Attach Fender Panels
Note:
Do not mix the 5/8” rail nuts (large) with the 5/8” hex nuts (small) (Figure 25).
Note:
Starting at the Backup, attach left and right Fender Panels shown below in Step(s) 4 & 5
with each tapered end pointing toward the rear of the system (p. 27).
Step 1
Place the Fender Panel so that the center of the slot of the rearward Diaphragm is lined
up with the approximate center of the slot in the Fender Panel.
Attach Mushroom Washer Assembly as shown in Figure 26, Detail 26a, and 26b. Do not
torque fasteners at this time. This (Step 1) helps to balance the Fender Panel.
Step 2
Slide the Fender Panel forward until the holes in the Fender Panel line up with the holes
in the forward Diaphragm.
Step 3
Use a drift pin to align the center hole of the Fender Panel with the center hole of the
Diaphragm.
Note:
Working from the Backup, assemble and tighten each Bay section one at a time toward
the Nose of the system.
Figure 25
Rail Nuts are Oversize
1.25” [32 mm] .94” [24 mm]
5/8” RAIL NUT (LARGE) 5/8” HEX NUT (SMALL)