VALTIR QuadGuard M10, Руководство по эксплуатации продукта

Страница: 34 / 60

Valtir.com 33 Revision F August 2022
11) Checking the System Assembly
At this point recheck to ensure that all fasteners are properly tightened throughout the
system (
anchor bolts , etc.). See torque requirements below. Check all Fender Panels. If
they do not fit tightly against the underlying Panel, system realignment may be necessary
(Figure 34).
Warning
Bolt Torque Requirements
Anchor Studs – p. 16
Critical Clearances
Anchor Studs above nuts – p. 24, Figure 20
Fender Panel Gap – .78” [20 mm] Figure 34
Figure 34
Fender Panel Gap
12) Cartridge Placement
The top surface of the Nose Cartridge should be horizontal. T o complete the assembly of a
QuadGuard ® M10, place the appropriate Cartridge in each Bay and Nose section of the
system. Type I Cartridges are placed toward the front (Nose) of the system; Type II
Cartridges are placed toward the rear (Backup) of the system (p. 19).
Warning:
Placing the wrong Cartridge in the Nose or Bay(s) could result in
unacceptable crash performance per MASH criteria and cause serious injury or
death to occupants and/or bystanders in the event of a vehicle impact .
Important:
The QuadGuard ® M10 is a six (6) Bay configuration.
MAXIMUM GAP = .78” [20 mm]
FENDER PANEL
UNDERLYING FENDER,
TRANSITION, EXTENSION
OR SIDE PANEL