VALTIR QuadGuard M10, Руководство по эксплуатации продукта

Страница: 23 / 60

Valtir.com 22 Revision F August 2022
2) Anchor the Tension Strut Backup (Figure 17)
Locate Tension Strut Backup and Monorail on foundation with side of Monorail on the
construction line (p. 24).
Verify that any applicable Transition Panels fit properly before
anchoring Backup. Drill 7/8” [22 mm] diameter by 5 3/4” [145 mm] anchor boreholes in
foundation using the Backup as template. Anchor the Backup to the concrete foundation
using an approved adhesive supplied with the QuadGuard
®
M10 (p. 16).
Note:
Verify that any applicable Transition Panels fit properly before anchoring Backup.
Caution:
Every hole in the Backup and Monorail must be anchored by a stud
using an approved adhesive (p. 16).
3)
Anchor the Monorail
Monorail Placement for Tension Strut Backup (Figure 21)
Locate Monorail on foundation with side of Monorail on the construction line and rear edge
of Backup foot 4” forward of edge of foundation.
Orient the Monorail so that the Monorail tongues face the Backup.
Warning:
Improper alignment at the Monorail splice joints may prevent proper
system collapse during an impact (p. 24, Detail 19a).
It is important to align each segment of Monorail from the back to the front of the system
(±1/4” [6 mm]). Anchor each Monorail section using the Valtir approved adhesive kits
provided (p. 16).
Figure 17
Anchoring Tension Strut
Backup to Foundation
TENSION STRUT BACKUP
APPROVED ADHESIVE
WITH 3/4 X 7 ANCHOR ASSEMBLY