VALTIR QuadGuard M10, Руководство по эксплуатации продукта, Страница: 14 / 60

Valtir.com 13 Revision F August 2022
Hammers

Sledgehammer

Standard hammer
Wrenches

Heavy duty 1/2” drive impact wrench

1/2" drive sockets: 7/16”, 9/16", 15/16", 1 1/16”, 1 1/8", 1 1/4"

1/2" drive Deep well sockets: 15/16", 1 1/4”

1/2" drive Ratchet and attachments

1/2" drive Breaker bar – 24” long

1/2" drive Torque wrench: 200 ft-lb

Combination wrench(s): 7/16”,9/16”, 15/16”, 1 1/8”

Hex Key (Allen) wrench: 3/8”
Important:
Valtir makes no recommendation whether use or reuse of any
part of the system is appropriate or acceptable following an impact. It is the
sole responsibility of the project engineer and/or the local highway authority
and its engineers to make that determination. It is critical that you inspect
this product after assembly is complete to make certain that the instructions
provided in this manual have been strictly followed.
Miscellaneous

Traffic control equipment

Lifting and moving equipment (A lifting device is preferred although a forklift can be used.)
Minimum 5,000 lb. capacity required.

Air Compressor (100 psi minimum) and Generator (5 kW)

Long pry bar

Drift pin 12” [300 mm]

Center punch

Tape measure 25’ [7.5 m]

Chalk line

Concrete marking pencil

Steel bristled tube brush for cleaning 7/8” drilled boreholes

Rags, water, and solvent for touch-up
Note:
The provided list of tools is a general recommendation and should not be
considered an extensive list. Depending on specific site conditions and the complexity of
the assembly specified by the appropriate highway authority, the required tools may vary.
Decisions as to what tools are needed to perform the job are entirely the responsibility of
the specifying highway authority and the authority’s selected contractor performing the
assembly of the system at the authority’s specified assembly site.