Vaisala RS41, Руководство пользователя

Страница: 34 / 124

User’s Guide ______________________________________________________________________
32 ___________________________________________________________________M211486EN-A
Set up the vacuum/pressure gauge as shown in Figure 12 on page 32 .
0106-008
Figure 12 Vacuum/Pressure Gauge
Set up the pump unit following the steps below:
1. Insert connector tube 1 into the locking nut (see number 3 in Figure
12 on page 32 ).
2. Push the tube over the tip of the connection screw on the gauge
(number 1).
3. Gently tighten the locking nut over the connector tube onto the
gauge (number 2).
Connection tube 3: cut a piece of tubing from EEC
sensor air inlet tubes to a length of approximately 3 cm,
or order separately. 17348S (by the
meter) or SPC
spare part No.
OTU-19
The following numbers refer to Figure 12 on page 32 :
1 = Gauge and connection screw
2 = Locking nut
3 = Connector tube 1
4 = Connector tube 2
5 = Connector tube 3
Table 7 Equipment Required for Pump Test
Unit (Continued)
Item Required Vaisala Part
Number