Configuring Audio Settings
A
UDIO PAGE
The web interface provides separate controls for each of the audio inputs and outputs. The EasyIP
Decoder provides simple input and output controls; the EasyIP Mixer provides the sophisticated controls of
a pro A/V solution.
Some of the settings are the same for both products. Others are only available on the EasyIP Mixer.
The EasyIP Decoder presents audio controls on two tabs –
Inputs
and
Outputs
.
The EasyIP Mixer groups the controls according to the signal type, and provides an audio matrix for routing
inputs to outputs. Audio tabs are:
n
Analog
– Line/Mic inputs 1 and 2 (typically the room's microphones) ; audio line out 1 and 2 (typically
the room's speakers).
n
Dante
– Up to four network-connected microphones or other audio inputs, and up to four speakers or
other audio outputs. Use the Dante Controller application to pair Dante devices to the EasyIP Mixer.
Use the Vaddio Dante Interface Application to access EasyIP microphone settings.
n
HDMI
– Left and right audio channels from the HDMI input device, and left and right audio channels to
the HDMI output.
n
Streaming
– Left and right audio channels for USB Playback (far-end audio) and USB Record (near-end
audio).
n
Matrix
– Defines the source (vertical axis) for each audio output (horizontal axis). Note that USB
playback cannot be the source for USB record.
Muting All Audio Inputs Together
A
LL PAGES
Use the audio mute button at the top of any page of the web interface. This control is present in the admin
interface and the operator's interface.
50
Complete Manual for EasyIP Systems
