To locate cameras on the network:
1. Select an EasyIP input tab. Then select Settings to open the Pairing box.
2. To find the IP addresses of EasyIP cameras on the same subnet as the EasyIP Decoder, select
Discover Devices. You can add a camera from another subnet by entering its hostname or IP address
in the Host/IP Address box.
3. Select one of the cameras from the list, and select Done.
Note
If a camera is paired to two or more EasyIP devices, more than one person can control the camera at
any given time. This can result in unexpected camera behavior.
4. Authenticate to the selected camera. If this is not successful, select the camera's IP address to open
its web interface in a separate browser tab, and complete the initial device set-up. Then authenticate to
the camera.
After you submit the correct admin password for the camera, its status shows as Connected. Select
Done to save the pairing.
To access a camera's web interface:
Select the hostname/IP address of the desired camera. Its web interface opens in a separate browser tab.
38
Complete Manual for EasyIP Systems
