vacuubrand VACUU-PURE 10, Инструкция по эксплуатации

Страница: 51 / 88

51 20901220_EN_VACUU·PURE 10_V1.6_060722
Commissioning (operation)
5.4 5.4 Connect / remove VACUU·BUS accessories Connect / remove VACUU·BUS accessories
Connect VACUU·BUS accessories
1. 1. Stop the vacuum pump and switch off the vacuum pump at
the power switch.
2. 2. Insert the VACUU·BUS plug of the accessory into the lower
socket on the back of the vacuum pump.
3. 3. Switch on the vacuum pump at the power switch. The
connected accessories are automatically detected.
5
VACUU·BUS accessories connected.
Remove VACUU·BUS accessories
1. 1. Stop the vacuum pump and switch off the vacuum pump at
the power switch.
2. 2. Unplug the VACUU·BUS accessories on the back of the
vacuum pump.
3. 3. Carry out a bus scan of the vacuum pump to deregister the
accessories from the vacuum pump bus system

see
chapter: 5.4.1 VACUU·BUS detection on page 52 5.4.1 VACUU·BUS detection on page 52
.
5
VACUU·BUS accessories removed.
General notes on VACUU·BUS components
ƒ
Use Y adapters and extension cables to connect and use several
VACUU·BUS components in parallel.
ƒ
A maximum of six VACUU·BUS components can be connected
and used in parallel.
ƒ
A maximum of four components of the same type can be
connected.
ƒ
Each connected VACUU·BUS component must have a different
VACUU·BUS address. The connection of two components with
identical VACUU·BUS addresses leads to errors in the bus
system. (Reconfiguration of the VACUU·BUS address of a
component: see manual of a VACUUBRAND VACUUBRAND controller, e.g.,
VACUU·SELECT).
ƒ
Note the maximum permissible load of 11 W at the VACUU·BUS
port.
Remove
VACUU·BUS
accessories
VACUU·BUS
accessories –
General information
Connect
VACUU·BUS
accessories