DS1098-019A
44
•
IP Channels:
if this option is enabled, it can be used to add the channels related to IP cameras to the group.
Important: a camera cannot be added to two or more groups at the same time
3.4.10.3
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) information
Click on [Main menu
Device
S.M.A.R.T.] to access the interface shown below.
Self-Monitoring, Analysis, and Reporting Technology, or S.M.A.R.T.,
is a hard drive and SSD monitoring system for detecting
and providing reliability indicators for the purpose of anticipating faults.
•
Whole Evaluation not passed, continue to use the disk:
if selected, this indicates that the HDD was not
completely analysed but the system can still use it
•
ID Hard Disk:
Identification of the HDD (set by system)
•
Self-check Type:
select the type of analysis to be performed on the HDD; the possible values are: Short or Whole
•
Self-check State:
this indicates the state of the check performed on the disc (if run)
•
TEMP (°C):
Temperature of the HDD
•
Utility Time (d):
Time of use (in days)
•
Whole Evaluation:
Result of the complete analysis of the HDD; the possible values are: PASSED or NOT PASSED
•
S.M.A.R.T. Info:
list of the information collected by the S.M.A.R.T. system and the results with reference values. The
information is mainly for use by expert personnel.
3.4.10.4 PTZ settings
Click on [
Main menu Device PTZ] to access the interface shown below.
Here you can select the desired channel to control and set the PTZ protocol (Pelco-D or Pelco-P, COAX) and the
respective Baud Rate (1200, 2400, 4800, 9600), Data bits (8, 7, 6, 5), Stop bits (1, 2), Parity Check (None, Odd, Even,
Mark, Space), Address Code and Cruise status. Note that the PTZ device may only be activated if a channel connected to
the PTZ/COAX camera has been selected.
