DS1098-019A
22
3.4.1.5
Privacy Zone
This function is used to configure the privacy zone parameters as shown in the following figure. Up to four privacy zones
can be selected for each channel. Proceed as follows:
1. Select the channel number.
2. Enable the Mask Area.
3. Select the area number (Area 1 ~ Area 4).
4. Click on [Setup] to adjust the position of the masked area.
5. At the end of this operation, right-click to go back to the [Privacy zone] interface.
6. Click on [Save] to save the previous setting.
3.4.2
RECORDINGS SET-UP
3.4.2.1
Record
Read the description under the following figures for this menu page:
•
Channel:
this is used to set the required channel.
•
Record Switch:
this is used to configure the recording state (Enable/Disable) of each channel.
•
Stream Mode:
this is used to set the stream type: Mainstream or Substream.
•
Pre-record:
the motion detection and recording activated by I/O support the Pre-record function.
