DS1098-019A
21
3.4.1.3
Output
Read the description under the following figures for this menu page:
Video output:
fixed value.
Seq Mode:
the layout can be set for the Sequence function.
SEQ Dwell Time:
time interval of the Sequence function. The default setting is 5 seconds. The user can edit this
setting as required. The minimum set time is 1 second.
VGA/HDMI Resolution
: this is used to select the VGA or HDMI output resolution. Default value: 1920x1080.
Transparency:
this is used to adjust the menu transparency within the 1~128 range.
Support Overscan:
enable this function if the image is not shown in full on a monitor (invisible menu bar).
3.4.1.4
Image Control:
Read the description under the following figures for this menu page:
Channel
: this is used to select the channel number.
IR-CUT Mode:
four modes are available: GPIO Auto, Colour, B/W and Video.
IR-CUT Delay:
delays IR-CUT switch activation.
Lens Flip:
the image can be turned upside down.
Angle Flip:
the image can be flipped vertically.
Back Light:
this is used to activate the backlight function.
3D Noise Reduction:
three states are available: Auto, Manual and Off.
Level:
3D noise reduction level.
WDR (Wide Dynamic Range):
this activates the function.
AGC (Automatic Gain Control):
this activates the function; four states are available: High, Low, Middle and
OFF.
White Balance:
three modes are available: Auto, Manual and Internal.
Shutter:
two modes are available: Auto and Manual.
Exposure Time:
this sets the function.
NOTE
:
This function is currently supported only for the IP camera set as private protocol.
