digiset
5
Urma AG, Switzerland www.urma.ch
page 44
8.2.3 Preset
The measuring lines are created on the contour of the object to be measured. Both
adjustment bars are hidden. The offset of the measuring lines and the fixed cross
hairs in the X and Z direction is taken into account with the current position.
You access this operating mode using the following menu steps:
Main menu
Sub-menu 1
Imaging
Ö
Preset
After selection the system analyses the object contour and automatically suggests a
measuring procedure for carrying out the measurements immediately. The measuring
procedure used is displayed in the status window at the same time. If an alternative
measuring method is required it is possible to enter the measuring procedure manu-
ally by pressing the button.
Procedure:
1. Move the object into the camera’s visual range.
2. If the relevant contour of the object is not clear, select the "Range" operating
mode and, using the mouse, make it the required size and drag it round the
relevant edge.
3. Select the operating mode as described above.
4. Digiset 5 automatically determines the best measuring procedure and the
test LED goes green. Depending on the measuring procedure selected
measuring lines are created on the object’s contour.
5. The object to be measured can now be set to the required size taking note
of the reading.
6. If the TCAM2 does not set the measuring procedure to your requirements,
change this manually.
The object to be measured must be in the camera’s focussing
area.
)
