digiset
5
Urma AG, Switzerland www.urma.ch
page 15
4.2.3
Align camera
When aligning the camera you must ensure that a known straight contour running parallel
to the vertical axis of your system also runs parallel to the vertical axis of the cross hairs in
the TCAM2.
You access this operating mode using the following menu steps:
Main menu
Sub-menu 1
Sub-menu 2
Setup
Ö
Imaging
Ö
Align camera
The TCAM2 then displays a histogram that shows the deviation away from the vertical
axis.
The displayed value for the angle should be
less than 0.02 °
Procedure:
1. Set the master mandrill on the screen it is not necessary to set in the cen-
tre.
2. Select the "Align camera" operating mode. The TCAM2 then goes into the
"Align camera" operating mode and you will see a histogram along the verti-
cal axis of the cross hairs. "Align camera" appears in the status window.
3. Turn the camera on its support around the optical axis until the histogram
has the smallest possible deviation.
)
