digiset
5
Urma AG, Switzerland www.urma.ch
page 21
•
If
no
measurement functions can be carried out correctly,
the test LED will be
red.
Then the data cannot be analysed or further processed by the user.
•
If the measurement can be carried out correctly,
the test LED will be
green
.
5.1.2.4 Measuring lines
The auxiliary lines determined by the TCAM2 using the object to be measured are
marked as measuring lines. They are shown in red.
In the "Fixed axis" operating mode the contour of the object must be aligned to these.
In the "Maximum" and "Preset" operating modes the measuring lines are attached to
the object.
The cross hair axes can also be shown in red as a measuring line
if the selected measuring function requires this, for example for
point measuring with the "Fixed axis" operating mode.
5.1.2.5 Analysis window
The analysis window is displayed as a square edged in red. It marks the area where
the TCAM2 carries out contour measurements so that the most interesting area can
be selected even with objects that have complex contours.
The size of the analysis window can be changed as required. After selecting the
"Range" operating mode, a new analysis window can be created by clicking any-
where in the live picture.
You access this operating mode using the following menu steps:
Main menu
Sub-menu 1
Imaging
Ö
Range
When the contour of the object to be measured is clear (line - ra-
dius - line) select the whole object field as the analysis window. If
several edges or complex contours are visible, restrict the analysis
window.
5.1.2.6 Measuring results
The measuring results calculated will be displayed on the corresponding position of
the object depending on the measuring programs selected, such as line, angle, ra-
dius etc.
If a radius is detected when analysing an object contour, this will be shown as a red
circle and the length of the radius shown in the circle. If the radius on the object con-
tour is smaller than 0.3 mm or larger than 20 mm this value will not be shown.
