33
3A.
XY Cutting Settings- Cut Offsets, Knife Pressure, and Stretch Factor
Cut Offsets, Knife Pressure, and Stretch Factor settings can be found in UNINET IColor PrintHub on the
XY Cutter Tab.
Cut Offsets If your cut does not line up with your printed image, you can adjust it using the Horizontal
Offset and Vertical Offset settings. Press the Send Test Print to help you determine which direction to
move the offsets or refer to the image below.
Knife Pressure affects how deep into the media
the knife will cut. Ideally, you want to cut deep
enough to cut through the label layer on the top
but not so deep that you cut through the backing
paper (liner). When you cut through the backing
paper your label will not peel cleaning off the
backing paper. You will also score the wear strip
under the cutting knife which can cause the knife
tip to break. You will also need to replace the
wear strip more often if you cut too deep.
By default, the cutter is calibrated to work with
High Gloss Paper Media. However, other media
types will need more or less cut pressure to cut
properly.
Each Roll of Media will have a recommended
value to add or subtract from the default baseline
values used for Knife Pressure and Knife Stretch
Factor. These values are listed below and printed
on a label attached to the inside of the core.
Содержание IColor 250
