Unimog U500, Инструкция по монтажу

Страница: 149 / 292

Body and Implement Mounting Guidelines U500 North America Implement / Body Installation
Page 152 of
294
August 2005
#
4.14.6.3 Mounting frame for a wing plow support
The following graphics and sketches show a concept for fastening of
a wing plow on a Unimog U500.
All figures, sketches and recommendations are without obligation.
All dimensions without brackets are in [mm] and all dimensions in
brackets are in [in].
The Unimog must be equipped with a self-supporting mounting
frame. Therefore the mounting frame must be fastened on the Uni-
mog chassis by use of heavy implement brackets (code D62) and
front fastening plates (code D70 included in code D62).
The entire forces resulting from the wing plow must be directly pref-
aced into the mounting frame. A force flow through the chassis
frame is prohibited and results in vehicle damage.
Unilateral (asymmetrical) weight distribution between wheel posi-
tions must be avoided (see Section 4.5, page 67).
The implement manufacturer is responsible for adequate de-
signing; dimensioning and construction of a wing plow and a
wing plow support on the Unimog!
Figure 4.111: Suggestion for self-supporting frame with a wing plow-
support
Figure 4.112: Example 1 for a wing plow on a Unimog
Figure 4.113: Example 2 for a wing plow on a Unimog