Unimog U500, Инструкция по монтажу

Страница: 117 / 292

Body and Implement Mounting Guidelines U500 North America Implement / Body Installation
Page 120 of
294
August 2005
Bodies on ballpoints of subframe P60 for vehicles with tipping
cylinder
Vehicles with tilt able platforms and tipping cylinders (code H43) are
equipped with a red tilt-warning lamp (code J48) in the instrument
panel ex works. This light up as soon as a small magnet is no longer
in the immediate vicinity of the tilt control sensor. The tilt control
sensor is mounted directly on the platform subframe (see Figure
4.74).
If an implement is mounted on the ball points of a vehicle equipped
with a tipping cylinder, the magnet (Part-no.: A000 546 07 88; see
Figure 4.73) on the implement frame must be mounted in the exact
position so that the tilt warning lamp is not permanently lit. The mag-
net must not be attached on the side of the chassis under any cir-
cumstances as this could cause a collision (damage to the magnet)
when the platform is mounted.
Figure 4.73: Magnet of the tilt-warning lamp
Figure 4.74: Position of the magnet and the tilt control sensor
Further drawings with the position of the magnet and the tilt control
sensor are shown on the following two pages.
This side to the tilt
control sensor
0.48 in / 12.2 mm
0.87 in / 22 mm
1.28 in / 32.4 mm