Unimog U500, Инструкция по монтажу

Страница: 157 / 292

Body and Implement Mounting Guidelines U500 North America Implement / Body Installation
Page 160 of
294
August 2005
4.14.7 Mounting space under the cab
There is a square cross-sectional area with 2.17 in x 2.17 in (55 mm
x 55 mm) clearance above the left longitudinal member of the chas-
sis frame under the cab. This installation space can be used, for ex-
ample, for a cable of a mid-mounted winch or water hoses etc.
Note: When code H93 or H94 (front connectors of the power
hydraulic system) is specified, the space under the cab
above the longitudinal frame member is used and cannot
used for other applications
4.14.8 Implement mounting between the axles
The implement mounting brackets (code D60 or D62) should be
used for fastening implement supports by implements, which must
be fitted between the axles (e.g. inter-axle road sweepers, road
scrapers etc.). Additionally it is possible to replace the bearing cover
on the rear stabilizer arm (see Figure 4.139 and Figure 4.140) with
an implement mounting support. An example of such a mounting
support is shown on the following pages.
The support on the rear stabilizer arms must not be loaded with
vertical forces (implement weight, self weight of mounting bars
etc.). These bearings may only be loaded with horizontal
forces!
Figure 4.139: Serial bearing
cover of the rear stabilizer arm Figure 4.140: Proposal for a
mounting support