Virhe. Määritä Aloitus-välilehdessä Heading 1, jota haluat käyttää tähän kirjoitettavaan
tekstiin.
12.
Connect to the UCD-400 Unit
Power on your UCD-400.
Connect UCD-400 with a USB cable to your PC through
Programmer
connector.
(Pls refer to page 7)
The programming interface is the Ethernet connector in the UCD-400 unit. Your PC can be
connected to the UCD-400 unit either through a network HUB or directly.
In case of direct connection, you need to configure your PC to be an Ethernet network host
by enabling WIFI network share (The WIFI network itself will not be used for
programming).
Please follow either of the two procedures below.
Connecting Through Ethernet Network
Connect UCD-400 though
Ethernet
connector to the same network HUB where your
programming PC is connected.
Connecting with Direct Ethernet Cable
Connect UCD-400 directly to your PC though
Ethernet
connector;
Enable
WIFI
Internet access of your PC.
From Laptop Wireless Network Connection Status > Properties and
Wireless Network Connection Properties > Sharing Tab
Select
Allow other network users to connect through this computer’s Internet
connection
In
Home networking connection
combo-box select
Local Area Connection
Click
OK
to close the window.
Note
The network sharing is shown above for Windows 7. Similar controls can be found
for other Windows versions and other operating systems.
Содержание UCD Console
Страница 1: ...UCD Console for UCD 400 User Manual ...