Close Control Regulation Program
06MC0071@00B0110
01/10/2012
9
UpCO: ASSIGNING THE LIST OF PRIVATE AND SHARED TERMINALS
The list of terminals associated with each individual UpCO board can be modified from the “Network Configuration”
menu, as follows:
1. select the address of the required board using the
ј
(up) /
љ
(down) buttons in the “Setup I/O Board” field
(only the boards that are effectively on-line can be selected) and confirm by pressing
(enter). If the
pLAN network is not working correctly, or no UpCO board is present, the field is not modifiable, and “--“
(two dashes) will be displayed;
2. Press the “Setup” button: the screens will be displayed in sequence, see Fig. 9
Fig. 9
3. now
the (enter) button is used to move the cursor from one field to the next, and
ј
(up) /
љ
(down)
change the value of the current field. The P:xx field shows the address of the selected board (in the
example, board number 12 has been selected);
4. to exit the configuration procedure and save the data, select the “OK ?” field, set “Yes” and confirm by
pressing
(enter). Alternatively, if the terminal remains inactive (no button is pressed) for more than 30 s,
the configuration procedure is automatically ended without saving the changes.
Important: the UTS01 terminals cannot be configured as “Sp” (shared printer) as the printer output is not featured.
Selecting this mode has no effect on the management of printed messages sent via pLAN.
“GENERAL OPTIONS” MENU
Fig. 10
The following options are possible:
•
Beep Volume: Used to set the volume associated to the buttons and the touch-screen pressing. The
possible values are “off”, “low”, “high”. Default: high. This parameter has no effect on the alarm signal,
which is activated or deactivated by the UpCO;
•
Beep On: Used to set when the “Beep” sounds. The possible values are: “active items” (associates a
sound with the active area of the display), “screen” (associates a sound with any point on the touch-
screen) and “screen & keys” (associates a sound with both the touch-screen and the keypad). Default:
“screen & keys”;
