3
YO20-0938-DI-001-00
1.2.2 Transfer
Do not use the casters as a transportation device or a means of
equipment support.
Although this pump is equipped with casters, do not use them as a
transportation device or a means of equipment support.
For transport, use cargo-handling equipment or a pallet truck.
To transport this machine, a load higher than the safety standards is required.
Therefore, manually transporting may cause lower back pain or injury. For
transport, hang this machine with cargo-handling equipment (such as a mobile
crane) or fix it on a pallet and then transport it by pallet truck.
1.2.3 Storage
Respect the environmental conditions
This machine has a precise clearance. Confirm the storage location and
satisfies the requirements listed in "3.1.2 Storage environment requirements."
1.3 Installation/Operation
Do not remove the face panel
Never remove the face panel. Failure to observe this instruction may lead to
burns or electrical shock.
Do not remove the casters
Do not remove the casters, and do not install this pump directly on the ground.
Do not apply shock to this machine or put in at an incline, position it
sideways, or stand it up or reverse it.
Do not apply shock to this machine or put in at an incline, position it sideways,
or stand it up or reverse it. Doing so will degrade the pump's operation. Install
this machine in a horizontal position to be leveled.
Operate this machine after its temperature reaches the operational
ambient temperature
If this machine was stored outside the range of the operational ambient
temperature, operate it after its temperature reaches the operational ambient
temperature.
Install this machine in a horizontal position to be leveled
After moving to the installation location, adjust the four adjusters within the
range of 0 to 10 mm and install this machine horizontally on the main unit. If you
operate with casters, vibration may be transmitted to the floor. In addition, this
machine may move itself and collide with surrounding equipment.
NOTES
NOTES
NOTES
NOTES
Содержание MS120A
