Owner's manual
ULTRAFLEX
page 12
of 36-
POWER A MK2
E
NG
L
ISH
It is possible to switch on the engines if the following conditions are met:
1) The lever must be set to the neutral position; a click is heard
when placing the lever vertically in order to reach such a position.
A mark on the control station package shows the lever neutral
position.
2) The key must be enabled;
3) No failure must prevent the shift from being set to the neutral
position and the throttle from being at idle. In this case a proper
acoustic/visual message will warn the user and the problem will
appear on the control unit display.
2.3.3 Engine switching on
The previous considerations are valid for both engines in case of twin-engine installations.
The engine start inhibition is ensured only if the proper switches have been connected as indicated in the
installation manual.
NOTA
NOTICE
DANGER
2.3.4 Control enabling
To control the system it is necessary to enable the required control station.
To carry out this operation, push key CTRL once if the following conditions are
met:
1) The lever must be in neutral position.
2) The panel key must be enabled.
3) No failure must prevent the control station from operating.
4) The other control stations are disabled.
When the control station is enabled, the relevant green LED lights up and the
buzzer turns off.
The control station can be partially enabled or cannot be enabled depending
on the conditions described above, since they could apply to a single engine or
to none of them.
If the control station is enabled partially, the green LED corresponding to the
disabled part of the system will keep on blinking and the buzzer will keep on
sounding.
