Owner's manual
ULTRAFLEX
E
NG
L
ISH
POWER A MK2
-
page 17
of 36
The TROLL mode allows the user to control the trolling-valve of each engine.
To enable this mode the following conditions must be met:
- The station must be enabled.
- All the other fucntions must be disabled.
- The levers must be in neutral position.
- There must be no failures that could prevent this mode from being enabled.
To enable the TROLL mode, keep key HIGH-IDLE
pressed for a few seconds. The mode is enabled
when the key is released.
The proper green LED will blink indicating that the
TROLL mode is on.
To disable the TROLL mode, keep the proper key
on the user interface pressed for a few seconds:
the TROLL green LED will switch off.
In a twin-engine system, the TROLL mode cannot be enabled on one engine only.
The TROLL mode is disabled when changing the control station.
2.4.4 Troll mode
WARNING
