Owner's manual
ULTRAFLEX
E
NG
L
ISH
POWER A MK2
-
page 13
of 36
To control the other side too, check the points described above then press key CTRL.
If the engine key is disabled while the station is enabled, the relevant LED will switch off indicating that that
side is disabled.
If there is a failure, the control station will produce an acoustic signal and the
red LEDs will blink: the left LED for the port engine (or single-engine boats)
and the right one for the right engine.
Each failure has got its own alarm code with a different sound sequence.
The display on the control unit will provide the user with more information
about the kind of alarm enabled.
If more control stations are installed on the boat, it is possible to use only one station at a time, therefore
only one control station at a time can be enabled.
To change station, keep key CTRL pressed for a few seconds to disable the controlled station.
The station can be disabled if:
1) The lever is in neutral position.
2) No failure prevents the control station from operating.
If these conditons occur, the control station will be disabled and the enabling procedure described above
can be carried out.
2.3.5 Multiple control stations
