Owner's manual
ULTRAFLEX
page 14
of 36-
POWER A MK2
E
NG
L
ISH
2.4 Use modes
This mode allows the user to vary the engine speed with the shift in neutral position.
To enable this mode the following conditions must be met:
- The station must be enabled.
- The lever must be in neutral position.
- There must be no failures that could cause problems during the enabling of this mode.
To enable the WARM-UP mode, press the proper
key on the user interface.
The WARM UP red LEDs will light up when the mode
is enabled.
In single-engine systems, only the left LED will light
up.
In twin-engine systems the WARM-UP mode can be enabled only on one engine: the proper LED will indicate
the engine on which this mode is enabled. In this case pay great attention not to accidentally start the
engine which is not in WARM UP mode.
The WARM-UP mode turns off when the controlled station is disabled and it does not turn on when the
station is enabled again.
To disable the WARM-UP mode the following conditions must be met:
- The lever must be in neutral position.
- There must be no failures that could prevent this mode from being disabled.
To disable the WARM-UP mode, press key WARM-UP. The WARM UP red LEDs switch off indicating that the
mode has been disabled,
In single-engine systems, only the left LED will switch off.
2.4.1 WARM UP mode
After enabling the desired station, it is possible to put into reverse or forward gear and adjust the engine
speed by moving the levers.
Similarly, if this function has been set up, the trim attitude can be modified by means of the two trim
switches on the port lever.
Moreover there are some functions that modify the control normal operation: WARM-UP, AUTOSYNC, HIGH-
IDLE, DOCKING, TROLL.
WARNING
