Owner's manual
ULTRAFLEX
E
NG
L
ISH
POWER A MK2
-
page 19
of 36
It is possible to increase or reduce the LED brightness on the user interface by keeping key WARM pressed
for a few seconds.
Each second the key is kept pressed, the LED brightness will increase up to the
maximum value. By keeping the key pressed, the brightness will be reduced to
the minimum, then increased again until the key is released.
To change the LED brightness, it is not necessary to enable the station.
The LED brightness will be changed only on the station which was controlled by
means of key WARM.
The new brightness value will be mantained until the system is switched off by means of the proper thermal
switch.
2.4.6 Panel brightness adjustment
