Owner's manual
ULTRAFLEX
E
NG
L
ISH
POWER A MK2
-
page 15
of 36
In twin-engine systems the WARM-UP mode can be disabled only on one engine: the proper LED will
indicate the engine on which this mode is enabled.
It is possible that the WARM-UP mode is enabled only on one engine and the control station meets the
conditions listed previously (levers in neutral positions, no failure): in this case, when pressing key WARM
again, this mode will be disabled on the engine on which it was enabled and viceversa.
To disable the WARM-UP mode on both the engines, do as follows:
- Put the lever of the engine in WARM-UP mode to the forward position.
- Press key WARM-UP.
- Move the aforementioned lever to the neutral position.
- Press key WARM-UP again.
WARNING
This mode allows the automatic synchronization of the engine speed of both the boat propulsors: the starboard
engine will adjust its revolutions according to the port engine.
This mode can be found on twin-engine systems only.
This mode can be enabled if at least one station is controlled regardless of the lever position by pressing
key SYNC on the user interface.
The green SYNC LED will light up without flashing
indicating that this mode has been enabled.
Under this condition, the engine synchronization
occurs if the following requirements are met:
- The difference in inclination between the levers
is lower than 15°.
- The throttle percentage of both the engines (which
is given by the levers) is higher than the 20% of
the total amount.
- Both the engines are put into forward gear.
The SYNC LED will blink when the engines are sinchronized.
The engine synchronization is enabled only when the proper LED is blinking.
When one of the previous conditions is not met anymore, the synchronization is
disabled but the SYNC mode is still on. When all the conditions are met, the
synchronization can be enabled again.
The SYNC LED on the user interface lights up without blinking when the
synchronization is disabled.
To disable the AUTOSYNC mode, press key SYNC: the green SYNC LED switches
off.
When changing the control station, the AUTOSYNC mode is disabled.
2.4.2 AUTOSYNC mode
WARNING
