24
25
Assembling
the Case
Adding the hinge hooks.
Now add the hinge hooks to the bar using the corresponding drilled
hole. If the glass groove is facing behind, the hole in the bar should
be to the left. The hook should be assembled so that it later closes
the door from above. Put the spacer washer on the drilled hole,
place the fastening hook on top of that, and then securely screw the
components together using the oval-head screw 2 x 12 so that
the hook can just be turned.
Assembly of the side bars on the base plate.
Screw the sidebars and base plate using the cylinder head Allen
screws M5 x 30 and the corresponding washers. The back sidebars
each have two glass grooves and are assembled so that the recesses
lie on the base plate facing inward to allow the later addition of the
seat-board. The two front side bars (each with one glass groove) are
also added this same way. It is important to note that the bar with
the hinges is added on the left. Please make sure that the recess lies
on top of the base plate toward the inside of the case.
Suggestion:
The side bar
with the fastening
hook goes on
the left side.
Adding the glass.
Now slide the side glass panes and the pane for the back into the
grooves of the side bars and base.
Adding the cornice.
Here it is best to put the pre-assembled case down on your
workspace. Before adding the pre-assembled case doors, put the
hinge pin into the bushing of the base. Make sure that when you
add the cornice, both the four wood pins of the side bars as well as
the upper hinge pin in its corresponding bushing find their way into
the corresponding drilled holes of the cornice. The cornice is
screwed on using four Allen cylinder head screws M5 x 30 and the
corresponding washers.
Recesses for
the seat-board
