26
27
Assembling
the Case
Adding the case’s feet.
Lock the case door using the fastening hook and turn the case
around and put it on its head to screw the feet on. The cornice
should be touching your workspace. Put the four square case feet
with the through-holes on top of the corresponding drilled holes
of the floor plate. Secure the feet using two countersunk-head
screws 2.5 x 8 and then furnish with a felt insert.
Putting the casing cover on the secret compartment.
Finally, turn the finished case back around so that it’s on its feet and
put the casing cover on the secret compartment. To secure its position,
the casing cover is outfitted with two magnetized fasteners on the left
and right sides. The little groove on the long end of the cover is there
to make taking the cover off easier and should be positioned toward
the back.
Suggestion:
For the following
steps of the
procedure, use
something like
the lid of the
packaging your M2
came in or a piece
of paper as your
underlay in order
to avoid scratching
the high-quality
case.
Now the case is completely assembled.
You should have the following components left unassembled of your
case: the seat-board with its Allen cylinder-head screws and washers.
The movement will later be added to the seat-board, placed inside the
case and secured there.
