Uhrenbausatz Mechanica M2, Инструкция по эксплуатации

Страница: 12 / 58

20 21
Assembling
the Case
Tools
Components
Get the following tools ready
for assembling the case:
◊
Watchmaker’s screwdriver Compartment (13)
◊
Standard screwdriver Compartment (13)
◊
Allen key 4 mm Compartment (13)
◊
Oil syringe Compartment (13)
Alongside the wood parts you have already oiled,
the entire case also comprises
the following components:
◊
Inlaid tile Bottom level
◊
2 x side glass panes Compartment (40+41)
◊
Glass pane for back Compartment (39)
◊
Door seal Bottom level
◊
2 x hinge pins Compartment (24)
◊
2 x round-head screws 2 x 12 Compartment (24)
◊
Fastening hook Compartment (24)
◊
Spacer washer Compartment (24)
◊
2 x hinge bushing Compartment (24)
◊
8 x case screws, cylinder head
allen screws M5 x 30
Compartment (25)
◊
8 x washers Compartment (25)
◊
4 x case feet Compartment (3)
◊
8 x countersunk-head screws 2.5 x 8 Compartment (3)
◊
4 x felt insert Compartment (16)
Tip:
To ensure the
proper look, put the
strips for the side
glass panes in the
front panels.
The case door is assembled first.
Slide the door glass back into the groove in the case door. Put the
lock rail in the groove. The upper edges of the lock rail and the case
door should be even. Then screw the lock rail from the back using the
two countersunk-head screws.
Slide the two hinge pins into the drillings on the front sides of the
upper and lower door panels.
In order to keep the door closed later, screw the round-head screw
2 x 12 into the drilled hole of the left door panel so that it sticks out
about 3-4 mm. This is the screw upon which the fastening hook will
hook into later.
N
Zubehör
Faceted mineral glass panes
To individually optimize the look of the case, we offer an alternative
to the standard glass panes: A set of faceted
*
mineral glass panes.
These can be used instead of the standard panes. It is important to
ensure that the facets are always on the outside. The faceted panes
are somewhat thinner on their edges and thus may have some room
to move in the grooves. To avoid this (and the sounds they make),
each set of panes also comes with rubber strips. These strips can be
placed in the glass groove of the case using tweezers.