ENGLISH
• Do not operate the coffee maker without water.
• The switches should be in the OFF position when
plugging them in or unplugging them.
• Do not unplug it by tugging on the cable or leave
the plug hanging freely.
• Keep the appliance and the cable away from hot
surfaces.
• If the cable becomes damaged it must only be
replaced by a qualified specialist, technical service
centre or the manufacturer.
• Do not switch the appliance on if the cable or the
plug are damaged or if it is not working correctly
• WARNING
WARNING
WARNING
WARNING
WARNING: To reduce the risk of fire or electric
shock, do not remove any of the covers.
There are no user serviceable parts on the inside.
Cable repairs and replacements must be carried out
exclusively by an Authorised Technical Service
Centre.
• This appliance has been designed exclusively for
domestic use.
Before using it for the first time, wash all of the
Before using it for the first time, wash all of the
Before using it for the first time, wash all of the
Before using it for the first time, wash all of the
Before using it for the first time, wash all of the
accessories and operate it once without any coffee.
accessories and operate it once without any coffee.
accessories and operate it once without any coffee.
accessories and operate it once without any coffee.
accessories and operate it once without any coffee.
PREPARING DRIP-FED COFFEE
(Fig. 2ª - 6ª)
1. Fill the tank (9) with cold water. A quantity of less
than two cups is not recommended.
2. Open the filter holder as shown in: (figure 1)
3. Place the permanent filter (8) into the filter holder
(7). Put in one tablespoonful of coffee for each cup
of water.
Note:
• This coffee maker can also be used with nº 1x4
paper filters.
• For correct operation, do not use coffee with
too fine a grind.
4. Place the jug (2), with its lid fitted, on to the hot
plate (1), plug the coffee maker into the mains and
press the switch (5) (figure 4). The pilot lamp
indicates that the coffee maker is working.
A cup of coffee can be served before the brew cycle
has finished. Whenever the jug is removed from the
hot plate, the drip feed will stop temporarily. Place
the jug back on the hot plate within 20 seconds.
NOTE: To keep the taste of drip-fed coffee constant,
we recommend that the drip-feed and espresso
coffee maker modes should not be used
simultaneously
PREPARING ESPRESSO
(Fig. 7 - 17)
1. Plug the appliance into the mains and make sure
that the ON/OFF switch (10) is off and that the steam
regulator (11) is closed.
2. Fill the water tank (9) with cold water (fig. 2)
3. This coffee maker is equipped with a BARCREAM
device (19) which fits inside the filter holder. This
disc ensures that creamy coffee is produced. (fig. 7)
Due to the way it works, you will see a small amount
of residual water inside the filter.
Place the BARCREAM disc into the filter holder. Fill
the filter using the coffee scoop (1 measure = 1 cup
- 2 measures = 2 cups) and place it inside the filter
holder on top of the BARCREAM disc.
Clean away any coffee that might be around the edge
of the filter holder.
This coffee maker can be used to make both
This coffee maker can be used to make both
This coffee maker can be used to make both
This coffee maker can be used to make both
This coffee maker can be used to make both
traditional percolated as well as espresso and
traditional percolated as well as espresso and
traditional percolated as well as espresso and
traditional percolated as well as espresso and
traditional percolated as well as espresso and
cappuccino coffee. Follow the instructions given
cappuccino coffee. Follow the instructions given
cappuccino coffee. Follow the instructions given
cappuccino coffee. Follow the instructions given
cappuccino coffee. Follow the instructions given
below to ensure that the appliance operates
below to ensure that the appliance operates
below to ensure that the appliance operates
below to ensure that the appliance operates
below to ensure that the appliance operates
correctly.
correctly.
correctly.
correctly.
correctly.
DESCRIPTION OF THE DRIP FEED
COFFEE MAKER
(Fig. 1)
1. Hot plate
2. Jug
3. Drip-stop valve
4. Water level
5. ON/OFF switch (Drip-feed function)
6. Drip-feed ON lamp
7. Swivel filter holder
8. Permanent filter
9. Water tank
DESCRIPTION OF THE ESPRESSO
COFFEE MAKER
(Fig. 7)
10. Coffee scoop compartment
11. Steam regulator
12. ON/OFF switch (Espresso function)
13. Espresso function ON lamp
14. Steam switch
15. Steam function ON lamp
16. Coffee outlet switch
17. Coffee/steam temperature reached lamp
18. Filter
19. BARCREAM aroma filter
20. Filter holder
21. Steam nozzle
22. Drip tray
23. Coffee scoop
24. Cable tidy
IMPORTANT NOTES
• Read these instructions carefully. Safeguard them
for future reference.
• Before plugging the coffee maker into the mains
supply, check that the voltage corresponds with that
stated on the characteristics plate. The use of an
earthed socket is recommended.
• Always place the appliance on a flat, level surface.
Avoid moving the appliance while it is operating.
• The glass jug is designed to be used with this coffee
maker. It must not be used on cooker hobs or in
micro-wave ovens. Never place the hot jug on cold
or damp surfaces. Do not pour cold water into the
jug while it is still hot. Do not use the jug if it is cracked
or if the handle has come loose.
• Do not leave the appliance operating unattended,
especially with children about.
• Do not touch the hot surfaces. Use the handles or
buttons.
• Never immerse the cable, plug or unit into water or
• Never immerse the cable, plug or unit into water or
• Never immerse the cable, plug or unit into water or
• Never immerse the cable, plug or unit into water or
• Never immerse the cable, plug or unit into water or
any other liquid.
any other liquid.
any other liquid.
any other liquid.
any other liquid.
• Always unplug the coffee maker when it is not in
use and before cleaning it. Leave it to cool down
before putting it away, removing any pieces and
before cleaning the appliance.
CK7360-2
23/4/04, 11:25
11
