µ-Dimension BST 1200es, Руководство пользователя

Страница: 69 / 74

Dimension BST 1200es / SST 1200es User Guide
Troubleshooting 69
The printer will then automatically build an XY
Calibration part (approximately 10 minutes). You must
inspect the XY Calibration part and calibrate the X and
Y axes for tip offset. See paragraphs 1 through 4 on
page 56.
Prepare Printer for Return to Service
1. Install plastic head cover.
2. Exit
Maintenance
- press
Next
> then
Done
.
3. Unload the material. Make sure that the cartridges are entirely
removed so that all of the filament loaded into the printer can
be withdrawn. (See
“Unloading Material” on page 36. .
NOTE
It is recommended that an unload be performed for each
material.
4. Load material (See “Loading Material” on page 32.
Clogged Liquefier Tip
Occasionally, a Liquefier Tip may clog with material. This is often
accompanied by a Loss of Extrusion (LOE). (Refer to
“Loss of
Extrusion” on page 63. ). A clogged Tip will prohibit material load.
Clearing A Clogged Liquefier Tip
NOTE
It is recommended that you read and understand this entire
procedure before performing any of the work.
This procedure assumes that filament is loaded to near the
liquefier tip. If filament has not been loaded,
see “Loading
Material” on page 32.