µ-Dimension BST 1200es, Руководство пользователя

Страница: 53 / 74

Dimension BST 1200es / SST 1200es User Guide
Maintenance 53
Figure 21: Identifying Tips
4. With gloved hand, insert the new tip into the heater block.
5. Use needle nose pliers to grasp the stainless steel shield of the
tip.
6. Pull the tip shield toward you, then lift up to install the tip.
7. Push the tip toward the back of the printer once it is all the way
up against the heater block.
8. Verify the tip is fully inserted into the heater block and that the
stainless steel shield is aligned (See Figure 22 on page 54 ).
9. Use 7/64 T-Handle Allen wrench to firmly tighten the heater
block clamp screws.
NOTE
Make sure Tip remains all the way up against the heater block as
you tighten the screws.