µ-Dimension BST 1200es, Руководство пользователя

Страница: 27 / 74

Dimension BST 1200es / SST 1200es User Guide
Setup 27
B. Click the ‘Add from Network...’ button in the lower right
corner of the pop-up.
C. A new pop-up, ‘Add 3D Printer’, should list your printer in
the main window (identified by its UDN). Click on the
printer in this window and enter a Name and Location (your
choice) in the lower portion of the pop-up.
NOTE
It may take up to 1 minute for your printer to appear in the
pop-up window.
D. Click ‘Add Printer’ - and you are ready to go. Close the 3D
Printer pop-up.
4. If your printer does not appear in the pop-up window:
A. Cancel the ‘Add 3D Printer’ pop-up and click the ‘Add
Manually’ button on the ‘3D Printers’ pop-up.
B. In the pop-up, ‘Add 3D Printer’, enter a Name and Location
(your choice) for your printer in the appropriate fields.
C. Enter the Dynamic IP Address for your printer (from Step
2C ) in the appropriate field.
D. Select the appropriate printer type from the drop down list.
E. Click ‘Add Printer’ and close the 3D Printer pop-up.
F. If you get an ‘Error: Unable to connect to printer.’ message
it may be that your PC is not configured for Dynamic
networking. To configure your PC for Dynamic networking:
(1). From the ‘Control Panel’ of your PC, choose ‘Network
and Internet Connections’.
(2). Choose ‘Network Connections’, then double click
‘Local Area Connection’.
(3). Scroll the ‘Local Area Connection Properties’ window
to find the ‘Internet Protocol’ (TCP/IP) selection. Dou-
ble click or highlight and click the ‘Properties’ button.
(4). From the ‘General’ Tab of the ‘Internet Protocol TCP/
IP’ Properties pop-up click the ‘Obtain an IP address
automatically’ radio button.
(5). Click OK, then OK again.