Tyco Fire Protection Products ANSUL CHECKFIRE 210, Планирование, установка, программирование, эксплуатация и руководство по обслуживанию

Страница: 114 / 132

SECTION 8 – RECHARGE, INSPECTION, AND MAINTENANCE
PAGE 8-6 REV. 0 2014-MAY-02
MAINTENANCE (Continued)
Five-Year PAD Replacement
1. The PAD (Protracting Actuation Device) must be replaced
after being in-service for five years.
a. The in-service date must be recorded in installation and
maintenance records and written on the PAD label with
permanent marker at the time of installation. See Figure
8-10.
b. The PAD has a 10-year shelf life when stored in an
environmentally stable location. The 5-year in-service
life may not extend beyond the 10-year shelf life. The
month and year of manufacture is printed on the label,
see Figure 8-11.
c. For proper disposal, the PAD must be actuated before
discarding. Actuate the PAD in a safe manner consis-
tent with site safety policies.
FIGURE 8-10
WRITE DATE ON PAD
009169
FIGURE 8-11
PAD MANUFACTURING DATE
009247
CAUTION
!
When handling the PAD, always point actuating end
away from yourself and others. On electrical initiation,
PAD operates very quickly and a small brass disk
forcefully separates from actuating end. Physical injury
may occur from contact with the actuating pin and/or
the detaching disk.
2. Write installation date on new PAD(s). DO NOT cover
manufacturing date on label. See Figure 8-10. Do not
install PAD(s) until testing is complete.
3. If needed, follow instructions in Section 5 – Installation and
Programming, page 5-9, to complete re-installation of the
Electric-Pneumatic Actuator.
4. Place in service by completing Table 6-6 – Placing
CHECKFIRE 210 System in Service, pages 6-20 – 6-22
(Section 6 – Operational Test and Place in Service).
5. Record date of PAD replacement in a permanent record
file. Notify operating personnel the system is back in
service.
CHECKFIRE 210
Detection and Actuation System
WRITE INSTALL DATE
ON LABEL
MAKE SURE
MANUFACTURING
DATE IS READABLE
MONTH AND YEAR
OF MANUFACTURE
ON LABEL