Tucker Auto-Mation SW10, Руководство по установке

Страница: 15 / 42

920.1020.12
15
STEP 5:
OPTIONAL - PULL ARM INSTALLATION WITH INCREASED
SPRING TENSION
• Apply 120 VAC Main power to the control
o
Place the On-Off-Hold switch to the Hold Open position
•
Observe the Stop Point Screw on the operator as it is opening and ensure that it rotates to the
full open position against the open door stop - leave
the switch in the Hold Open position
•
Manually move the door panel to the 90 degree
open position
•
The pull arm assembly is a fixed dimension and is
not adjustable in length
•
Install the arm and spindle adaptor to each other
(7,8,9) and insert it into the operator at a position
that allows the slide block to go in the door-
mounted slide track. If it does not align exactly,
install the arm so that it is past the open door. Once
it is in place, tighten the main adaptor bolt to secure
the arm to the operator.
•
If the arm alignment was not exact, perform the
following:
o
Place the On-Off-Hold switch to the OFF position and allow the door to close.
o
Loosen the "open door" mechanical stop on the operator.
o
Manually move the door to the desired full open position.
o
Slide the open door mechanical stop to meet the stop point screw - refer to the next
section if additional instruction is required.
o
Tighten the stop and double check the actual open door position.
•
Place the On-Off-Hold switch to the ON position.
•
Press and hold button SW1 to launch a new setup